成功案例
     成功案例
     新闻事件
     展会动态
     职业机会
成功案例—生活用品 Living goods

应用案例(Application):生活用品 Living goods

材料(Resin):PPE

重量(Weight):30g*8

颜色(Color):黑色  black

平均壁厚(Wall Thickness):2.0mm

系统(System Type):PRM VV-EP

热咀点数(Nozzle Qty):8

型腔数(Cavity):8 

项目特性及客户要求

Project characteristics and customer requirements

  一、此产品材料为混合型改性工程材料、阻燃,成型温度较高、且温度范围窄,温度控制不好时易碳化与分解。因此分流板与热咀的温度须要做到精确、均衡控制,为此该套热流道系统热咀采用最新热咀——工程材料专用咀(PRM-EP);

  1.The materials of this product is mixed type of modified engineering resin with flame retardant.

The molding temperature is high and narrow scope for temperature. It will be carbonized and decomposed easily if the temperature is controlled not well. So the temperature of manifold and nozzle must be accurate and balanced control. Thus,the nozzle of this hot runner system use the newest nozzle,it’s the specialized nozzle for engineering resin(PRM-EP).   二、此种热咀为两段铜套加热器,咀头与法兰处独立控制温度,能很好地保证热咀整体温度及其稳定性; 

 2.This nozzle with two segments copper tube heater. The head of nozzle and flange can control the temperature separately.

So it can ensure the overall temperature of nozzle and it’s stability.

  三、产品一出八,分流板温度均衡、流道特殊设计,保证填充稳定同时避免死角(碳化)、以及减少压力。

  3.The quantities of cavities is 8 for each mould. Balance temperature of distributed flow of manifold. Specialized design for runner.Thus,it can ensure filling balance and stability.At the same time,it can avoid the dead corner (carbonization) and reduce the pressure.

 

 

 

 
Get the Flash Player to see this player.

 

 
版权所有© 先锐模具配件(东莞)有限公司粤ICP备17105487号